Quote:
Tnx but why when the mag is inserted in very strong way it works? and when it shots the first bb, all bb's are fired well?
Today I installed the Guarder steel mag catch but the issue is still here
About a strongest hammer spring, I am waiting for the Guarder recoil set, which includes the hammer spring I think and the steel valve knocker
I never taken apart the hammer mechanism of a Glock, do you know about a tutorial on the web?
|
The magazine will only be inserted as high up as the magazine base allows. If it fires normally when you push it in with force, there is some sort misalign taking place between the valve knocker and the magazine valve. So to re-iterate what ILLusion says, install the enhanced hammer spring to create a good strike. If you find that the magazine is still causing trouble, I would look at how it sits in the magazine chamber with the slide off.
Here's a neat little expirement. Take your slide off. Charge and Insert the troublesome magazine. And pull the trigger.
From here you should be able to observe two things:
1). If you get a face full of air, then the magazine valve and firing pin is correctly inserted and it is functioning properly.
This means that the problem occurs when the slide is ON. At that point, you can assume that the slide is causing your magazine to sit a bit lower than it nominally should be thereby causing your problem.
You can then tailor a fix for it accordingly.
2). If it doesn't fire properly, you can see how the firing pin is hitting the magazine valve. You can then tailor your modification accordingly to properly optimize the strike face of both the valve and firing pin so that each is able to interact with each other efficiently.