Airsoft Canada - View Single Post - Cutting an inner barrel

Stealth · February 27th, 2013, 21:05

Okay whoa wait a minute.

What barrel are you cutting exactly? Because if you're cutting a Madbull or any kind of coated barrel you're going to crack the coating on it.
If it's a steel barrel, good luck using a hacksaw on that.
And if it's brass you're going to want to stabilize the barrel completely before cutting it to prevent warping as it's quite a bit softer than other barrels.

February 27th, 2013, 21:05	#10
Stealth Mr. Silencer Trader rating Join Date: Dec 2001 Location: Toronto	Okay whoa wait a minute. What barrel are you cutting exactly? Because if you're cutting a Madbull or any kind of coated barrel you're going to crack the coating on it. If it's a steel barrel, good luck using a hacksaw on that. And if it's brass you're going to want to stabilize the barrel completely before cutting it to prevent warping as it's quite a bit softer than other barrels. Last edited by Stealth; February 27th, 2013 at 21:07..