Airsoft Canada - View Single Post

e-luder · February 6th, 2013, 20:30

I dont get how you're trigger "is released" if you're hammer is not functioning. If you're hammer cant be fired, your valve knocker can't actuate. Therefore no air passes to blow the slide back to trip the trigger bar for the reset.

The reason why you have to press the slide down to release the hammer is because the full auto sear is not being pressed. thus it hangs unto the hammer forever. So it's either worn or....

another issue is that the slide is being spaced apart either by the mag or the hammer bearing. if notice wobbling, this is probably the case. if this happens the slide cant trip the full auto sear.

February 6th, 2013, 20:30	#5
e-luder Trader rating Join Date: Aug 2011 Location: Centre Mass	I dont get how you're trigger "is released" if you're hammer is not functioning. If you're hammer cant be fired, your valve knocker can't actuate. Therefore no air passes to blow the slide back to trip the trigger bar for the reset. The reason why you have to press the slide down to release the hammer is because the full auto sear is not being pressed. thus it hangs unto the hammer forever. So it's either worn or.... another issue is that the slide is being spaced apart either by the mag or the hammer bearing. if notice wobbling, this is probably the case. if this happens the slide cant trip the full auto sear. __________________ "May you fight with the strength of ten full grown men." Last edited by e-luder; February 6th, 2013 at 23:31..