Airsoft Canada - View Single Post

ThunderCactus · November 27th, 2012, 23:44

I'm running an 11.1v LiPo on mine, that's a max of 12.6v
What saves the motor is those tiny little wires choking all the current trying to go through.
It will get hot for sure, but mine lasted over a year and a half and ended up stripping one of the plastic gears before doing any motor damage

Also may be worth noting, the boards on these box mags don't like anything above 9.6v
My 11.1v LiPo would cause the motor to trickle down in speed then stay on at very low speed. I don't know shit about electronics, I just know the problem is caused by an 11.1v LiPo lol
You're better off having the pressure switch only anyway, there's no use feeding ammo when you don't need it to.

November 27th, 2012, 23:44	#10
ThunderCactus Not Eye Safe, Pretty Boy Maximus on the field take his picture! Trader rating Join Date: Feb 2007	I'm running an 11.1v LiPo on mine, that's a max of 12.6v What saves the motor is those tiny little wires choking all the current trying to go through. It will get hot for sure, but mine lasted over a year and a half and ended up stripping one of the plastic gears before doing any motor damage Also may be worth noting, the boards on these box mags don't like anything above 9.6v My 11.1v LiPo would cause the motor to trickle down in speed then stay on at very low speed. I don't know shit about electronics, I just know the problem is caused by an 11.1v LiPo lol You're better off having the pressure switch only anyway, there's no use feeding ammo when you don't need it to. Last edited by ThunderCactus; November 27th, 2012 at 23:46..