Airsoft Canada - View Single Post

heavyzero · May 3rd, 2012, 19:24

I have recently switched out the air nozzle and piston head in my clone pdw. its a v2 mechbox. My PROBLEM is that after i tore th gearbox apart 3 times, is that the new nozzle sticks out too far into the hopup. the gears cycle just fine.
what has me scratching my head is that the new nozzle is the same length as the old one. the only difference is its brass instead of plastic. i never had this problem before with the old nozzle and my tappet plate has never given me any issues and appears normal. compression is also alot better which is what i want, but now BB's will not feed into the chamber they are blocked by the nozzle.

Can anyone give me any advice please???, it would be greatly appreciated.

May 3rd, 2012, 19:24	#1
heavyzero Trader rating Join Date: Feb 2009 Location: burlington	air nozzle sticking out too far. I have recently switched out the air nozzle and piston head in my clone pdw. its a v2 mechbox. My PROBLEM is that after i tore th gearbox apart 3 times, is that the new nozzle sticks out too far into the hopup. the gears cycle just fine. what has me scratching my head is that the new nozzle is the same length as the old one. the only difference is its brass instead of plastic. i never had this problem before with the old nozzle and my tappet plate has never given me any issues and appears normal. compression is also alot better which is what i want, but now BB's will not feed into the chamber they are blocked by the nozzle. Can anyone give me any advice please???, it would be greatly appreciated.