Quote:
Originally Posted by Danke
That T would capture the spring nicely Something to really locate the nub would be good. If it walked sideways you'd be side hopping. A grub screw or roll pin put through back to front would nail it down.
One other thing would be the mass of the arm. I think if it was heavier it would be less likely to wander from the vibration going through it.
|
I suppose I'll add a grub on request, but most of these will probably be used with my nubs, which will be rubber. The upper portion of the nub will be larger than the socket, so the compression/friction will keep it in place.
I'll see what I can do about weights as well
Thought I might play around with the idea of a rotatable nub, although I don't think my nubs would use it...
