Airsoft Canada - View Single Post - Finishing up a dmr, and need parts advice.

iKliiu · December 1st, 2011, 07:55

If you want cheap and good, go Madbull barrel. If you want to spend more, go prometheus.

For hop up rubber, any will do. Just remove the internal mound in the bucking and you will get more range (flat hop).

Definitely get a ACM neodymium motor. They're roughly $20-30 and got amazing torque. If you want to spend some more, get a Lonex torque motor; that thing has crazy torque and barely heats up.

If you do get a ACM torque motor, I strongly suggest a high discharge LiPo. Those motors are power hungry and require a lot of start up energy. Make sure you have a mosfet if you are using a LiPo though.

December 1st, 2011, 07:55	#8
iKliiu Trader rating Join Date: Aug 2010	If you want cheap and good, go Madbull barrel. If you want to spend more, go prometheus. For hop up rubber, any will do. Just remove the internal mound in the bucking and you will get more range (flat hop). Definitely get a ACM neodymium motor. They're roughly $20-30 and got amazing torque. If you want to spend some more, get a Lonex torque motor; that thing has crazy torque and barely heats up. If you do get a ACM torque motor, I strongly suggest a high discharge LiPo. Those motors are power hungry and require a lot of start up energy. Make sure you have a mosfet if you are using a LiPo though.