Airsoft Canada - View Single Post - Question about WE G39c -solved-

Stocko · August 30th, 2011, 10:33

I have a we g39c, that was recently serviced by a gun tech (put in a npas).
Now it was shooting fine, when I first got it back but then after a few days later I tried it and it seems to shoot the first 20 bbs then shoot blanks and expel the gas from the gun. And sometimes it would be able to shoot all 30 rounds but would be shooting blanks in-between 20-30 rounds.

I tried dropping a drop of silcon oil into the output piece at the top and dropped silcon oil in the propane tank and filled the mags. When I did that it seemed to work much better but it still shooting some blanks in-between the 20-30 rounds.

Is there anything I can do? Or should I dry fire this thing with some
Silcon oil?

Thanks guys.

---------------------------------------------------------------------------

It seems that I was low on propane, and additionally the hop up was maxed out. thus the bbs were probably sitting a bit too far for the nozzle to even touch. Just my theory.

Used a new tank, added silcone oil, dialed the hop off, BOOM BOOM BANG!

August 30th, 2011, 10:33	#1
Stocko Trader rating Join Date: Jan 2009 Location: Toronto, Ontario	Question about WE G39c -solved- I have a we g39c, that was recently serviced by a gun tech (put in a npas). Now it was shooting fine, when I first got it back but then after a few days later I tried it and it seems to shoot the first 20 bbs then shoot blanks and expel the gas from the gun. And sometimes it would be able to shoot all 30 rounds but would be shooting blanks in-between 20-30 rounds. I tried dropping a drop of silcon oil into the output piece at the top and dropped silcon oil in the propane tank and filled the mags. When I did that it seemed to work much better but it still shooting some blanks in-between the 20-30 rounds. Is there anything I can do? Or should I dry fire this thing with some Silcon oil? Thanks guys. --------------------------------------------------------------------------- It seems that I was low on propane, and additionally the hop up was maxed out. thus the bbs were probably sitting a bit too far for the nozzle to even touch. Just my theory. Used a new tank, added silcone oil, dialed the hop off, BOOM BOOM BANG! Last edited by Stocko; September 12th, 2011 at 00:27..