Quote:
Originally Posted by Amos
Ok!
There's no .20 ECO Bastards, so you would have chrono'd with .25.
387 with .25 is 433 FPS. The chronos at Claybank were also very messed up because when people hit the sides, the people operating them did not clean the BB shavings off of the sensor gates. There were some stock TM guns that where chronoing over 500 one shot, then 290 the next lol
Try a 2.5mm allen key.. If I'm correct, that's the one that should adjust it.
The gear noise could very easily be your re-shimming. I checked and corrected the shimming when I got it from the guy you got it from. It was fine when it left.
|
Sorry I wish I remember what the BBs were. I believe it were Gishs BBs. I do not remember what they were using to chrono. I was told that they were .20s though.
I'll check the shimming/try again. I bet your shimming job was great, its just that I couldn't tell exactly where it came from apparently.
EDIT: YES! It was a 2.0 mm hex key. There was some gunk in the bottom and I had to scrape it out before I could turn. Now it sounds worlds better. Thanks everyone! I'm going to do some more testing tomorrow to be sure, but it looks all good now!