[Kos-Mos]

Originally Posted by Infamous0ne

This is what I'm thinking of throwing in this year:
PDI Hop Up
Prometheus Bucking (hard)
PDI 6.01mm Inner Barrel The stock inner is 500mm, but this is noted to work in the L96 with the PDI Hop Up upgrade, should I trust that statement?
Barrel Spacers x2 Giving me four to put down the length of the barrel

First two is good.

I personally prefer a Prometheus 6.03 as a tightbore. From past experience, if you want to keep the stock barrel cap, a M14 500mm barrel fits. It says for M14 only, but the PDI hop-up relies on two set screws to hold the barrel in place, so the cut-out for the plastic clip does not need to be at the same place as AEG barrels.

You also only really need 2 spacers, plus the hop-up and barrel cap... Just place the spacers on the inner-barrel evenly, then add 5 turns of electrical tape on either side of each spacer. That will help you a lot in fitting it in the gun.