Airsoft Canada - View Single Post

lord_sid · April 13th, 2011, 20:34

I had the same problem with my older aug.

I fixed it by using epoxy. Just make add the epoxy to the channel to make it flush across the whole thing. Let it dry. Grind out a new edge for the trigger to catch on.

Make sure the new edge is the correct location on the part. if its to far from the edge of the part, it wont fire semi at the first stage of the trigger. If its to near the edge of the part, it will fire before you finish the full pull of the first stage of the trigger.

I can take a pic of mine if you want (i would need to take it apart)

You can't use a standard v3 part because the aug one is a bit longer.

April 13th, 2011, 20:34	#2
lord_sid Trader rating Join Date: Oct 2004 Location: Windsor, Ontario	I had the same problem with my older aug. I fixed it by using epoxy. Just make add the epoxy to the channel to make it flush across the whole thing. Let it dry. Grind out a new edge for the trigger to catch on. Make sure the new edge is the correct location on the part. if its to far from the edge of the part, it wont fire semi at the first stage of the trigger. If its to near the edge of the part, it will fire before you finish the full pull of the first stage of the trigger. I can take a pic of mine if you want (i would need to take it apart) You can't use a standard v3 part because the aug one is a bit longer. __________________ TM Steyr Aug A2 (Phantom) : TM Steyr Aug A2 (RIS) : Aftermath Steyr A2 (CQB) : APS Aug A1 H-Bar - 10 Low-Cap, 4 Mid-Cap and 2 Real-Cap Mags TM/KJW G26 - 4 Mags KJW KP-05 Hi-Capa - 2 Regular and 5 Extended Mags Crossman S36P DEAD - 14 Shells Old Buy/Sell Feedback