Airsoft Canada - View Single Post - Installed a new motor, jam happened after.

SPK · April 1st, 2011, 22:45

Hello,

I just replaced the motor in V3 Gearbox,
The spring in it is a SP120, had been working on it for at least 2 years, it also used to have a TM EG1000 and a stock Cyma cm028 motor.

Worked fine until I change the motor, I even cleaned the whole gearbox, then it worked, for a few shots, until I reassemble the whole gun, and to see it just do a lil "zap" and while I can actually feel the inner working, like they're trying to pull the spring.

Other infos :`
Battery used
Intellect 9.6v mini 1400mAh
G&G 9.6v mini 1600mAh
Sanyo 9.6v mini 1600mAh.
Every parts in the gearbox looks fine and aren't stock, been the same since 2008.

Note that I'm not a newbie at upgrading/fixing rifle, I've been doing it for a little bit more than two years, and often, but yeah, this is an issue I wonder what may be causing.

April 1st, 2011, 22:45	#1
SPK Trader rating Join Date: Feb 2011 Location: Chicoutimi, Québec.	Installed a new motor, jam happened after. Hello, I just replaced the motor in V3 Gearbox, The spring in it is a SP120, had been working on it for at least 2 years, it also used to have a TM EG1000 and a stock Cyma cm028 motor. Worked fine until I change the motor, I even cleaned the whole gearbox, then it worked, for a few shots, until I reassemble the whole gun, and to see it just do a lil "zap" and while I can actually feel the inner working, like they're trying to pull the spring. Other infos :` Battery used Intellect 9.6v mini 1400mAh G&G 9.6v mini 1600mAh Sanyo 9.6v mini 1600mAh. Every parts in the gearbox looks fine and aren't stock, been the same since 2008. Note that I'm not a newbie at upgrading/fixing rifle, I've been doing it for a little bit more than two years, and often, but yeah, this is an issue I wonder what may be causing.