Quote:
Originally Posted by abbadon
had a similar problem with mine after i switched out some of the stock internals. pull out your mag, look into the receiver and see if the nozzle is sticking out or not, cycle it once and see where it ends up. that was my problem, in auto it would jerk back just enough to feed, but in semi it didn't. i ghettoed it by just taking a file and shaving a bit off the end of the nozzle. haven't had a problem, and get a consistent 368-372 on .20
|
+1
try this but dont remove any more than half a millimetre. the sector chip will also work.