Quote:
Originally Posted by ILLusion
Neither.
|
What!?
Quote:
Originally Posted by ILLusion
The hammer should have also come with a small steel pin that goes in to the hole at the bottom of the hammer.
|
Yes!
Quote:
Originally Posted by ILLusion
On your picture, it fills the hole that is just to the left of hammer hook "#2".
|
Correct.
Quote:
Originally Posted by ILLusion
Remove that pin. That location only works with Hi-Capa. It will not function with 1911/MEU type frame.
|
I just tested without it and it work! Damn, I compared with original and it have this pin, so i always installed it.
MANY THANKS!
Quote:
Originally Posted by ILLusion
Depends what you want to achieve, if you want higher FPS, get Nine Ball. If you want higher accuracy, get Firefly.
BOTH brands will increase both characteristics, but one just does a characteristic better than the other.
The KM ones, I found did not fit well, and I never did much experimentation with it. I'm willing to try them again, but until then, I can not fully comment on it.
|
O.K. I have got KM one and PDI palsonite barrel. I think it fit good.
Quote:
Originally Posted by fyra
What does that sights that come with the Nova Kimber Warrior kit look like, i.e. sight picture? It says that they are "Novak style", but is that a tri-dot sight, or just black like the stock MEU sights?
|
Sorry, i have got Kimber Desert Warrior Kit from HurricanE.
On HurricanE it's Novak style, tri-dot, but no any glow (both: tritium or phosphorus) and no markings on rear sight. Front sight have got "MH3" on left side. Rear sighe have got serrations on both sides.
Quote:
Originally Posted by fyra
I have had very good results with the Nine Ball rubber. Used it with a 6.03 Nine Ball TBB and the TK Hop Twist.
Out of the two barrels, I prefer the TK one. It shoots longer, but not necessarily with higher velosity.
|
With original Hop-Up rubber and PDI i can't hit center. BBs always go up and left. Not tested with KM yet.