|
I had an ACM M500 and mine broke too.
You should take the parts to a machinist and have him make one out of aluminium or even nylon/delrin. That part is the load point for the magasine tubes and it will break again even if you replace it.
The long version of the M500 does not have heat shield.
If you bought replacement lever arms, you will probably break them again. Real M500 levers will fit without any mod and are impossible to break. I had some installed on mine and 1-hand cocking was not even an issue.
__________________
Quote:
Originally Posted by Drake
Damnit, don't make me add "no discussing temporal paradoxes" to the rules or I'll go back in time and ban you last week.
|
|