Airsoft Canada - View Single Post

Bob Essensa · November 18th, 2010, 00:56

I have looked everywhere and i cannot seam to find an answer. I have a G&G M4 Mechbox and i recently ordered a G&P Metal body from Ehobby. So i dissasembled the G&G and thought hey this will be pretty easy to install. The G&P Body did not come with a fire selector, so i removed the one from the g&G and installed it on the G&P body. Now while dropping in the gear box, the trigger pin will not go through the mechbox AND line up with the other side of the body hole. This goes for the rear body pin as well. The fire selector switch does not snap into place when i attempt to switch it from safe to semi to full auto either.

Any suggestions? Or do i need an all new mechbox to make this build complete?

Thanks in advance.

November 18th, 2010, 00:56	#1
Bob Essensa Trader rating Join Date: Nov 2010 Location: Florida	G&G + G&P Fustrations I have looked everywhere and i cannot seam to find an answer. I have a G&G M4 Mechbox and i recently ordered a G&P Metal body from Ehobby. So i dissasembled the G&G and thought hey this will be pretty easy to install. The G&P Body did not come with a fire selector, so i removed the one from the g&G and installed it on the G&P body. Now while dropping in the gear box, the trigger pin will not go through the mechbox AND line up with the other side of the body hole. This goes for the rear body pin as well. The fire selector switch does not snap into place when i attempt to switch it from safe to semi to full auto either. Any suggestions? Or do i need an all new mechbox to make this build complete? Thanks in advance.