Quote:
Originally Posted by RacingManiac
Would the stock spring have enough tension still to feed reliably at a more "relaxed" state?
As I said on GGI though, I'd be all for this. One of the area where the TM single stack is lacking is a variety of mags. For WA they have the long mag, compact and sub-compact mag....maybe then someone can make a compact TM 1911 metal kit...and have mag for it....
|
On the prototype I created, I used a stock KJW mag/follower spring and it worked fine.
Ideally, I'd love to be able to offer a complete mag, and I will strive to do so - but the $$$ will be higher unless I can get a line on low-cost (but reliable) components.
I should note that I refuse to make a product that is inferior to a stock TM magazine, and if it means only experienced or intermediate users can assemble them for the time-being - I think that's a trade-off us experienced users would be willing to make. Like I said - at least for the immediate future.
Correct me if I'm wrong though.
Also - 1911 mags are not very difficult to assemble/disassemble. The only issue I can foresee, would be the inclusion of a valve-key; For both the fill-valve and the output-valve. Which is easy enough to machine.
Great comments so far everyone - keep them coming. Your feedback is very valuable.