Good job Coachster, real useful thread for the community.
One way I (accidentally, I didn't empty all the gas) found works to get the base out of the mag is to empty the mag of gas, put a little spurt of gas in the mag, then push the pins out. The base will pop out (put thumb over the top of it, it may pop out halfway, or more) allowing you to remove it easily. And as was asked, the seal is a medium soft silicon rubber so there shouldn't be any problem with breaking that seal to get the base off again.
Hehe, just saw Amos post about gassing the mag up to get the base out, I didn't read page 2.
|