Quote:
Originally Posted by jtf2-phalanx
If what I think is correct, you have a lower body that needs a two piece hopup. I believe cutting the excess part very carefully should work. At least that's what I've done in the past but I haven't work on a G&G M4 before.
|
Yeah this is what I was thinking as well. I cut down a TM M16A1 body to fit a 2 piece hop up unit. It was pretty simple since you can cut away pretty much everything at the front around where the hop up is down to the walls of the magwell. If you look at the body for a 2-piece unit, there is nothing in the magwell until you get back to the little ring area for the mag catch.