Airsoft Canada - View Single Post

Relja · June 4th, 2009, 02:09

Hey Guys,

Im having a problem with my new CA36K. I tried to swap the mechbox for a TM G36 V3. The TM mechbox when placed into the lower receiver creates a problem for putting in the retaining pin and to allign the motor so that i may tighten the large phillips screw at the bottom of the handgrip. I believe it is the mechboxes problem as when i tried the same thing with the standard CA mechbox i had no problems whatsoever, but when i tried the same thing with my friends clone G36 V3 mechbox i had the same problem. We tried both mecboxes several times to no avail, but the CA fit in perfectly. Has anyone else had this problem?

http://www.mechbox.com/g36/g36c-reassembly.html at 1:40 + a few seconds for putting in the retaining pin.

June 4th, 2009, 02:09	#1
Relja Trader rating Join Date: Aug 2007 Location: Cooksville, Mississauga, Ontario	CA36K will not accept other mechboxes Hey Guys, Im having a problem with my new CA36K. I tried to swap the mechbox for a TM G36 V3. The TM mechbox when placed into the lower receiver creates a problem for putting in the retaining pin and to allign the motor so that i may tighten the large phillips screw at the bottom of the handgrip. I believe it is the mechboxes problem as when i tried the same thing with the standard CA mechbox i had no problems whatsoever, but when i tried the same thing with my friends clone G36 V3 mechbox i had the same problem. We tried both mecboxes several times to no avail, but the CA fit in perfectly. Has anyone else had this problem? http://www.mechbox.com/g36/g36c-reassembly.html at 1:40 + a few seconds for putting in the retaining pin.