Airsoft Canada > Search Forums Search Results			User Name Remember Me? Password

Showing results 1 to 33 of 33 Search took 0.26 seconds. Search: Posts Made By: Ourindar

Forum: Gear Discussion June 10th, 2020, 19:12

Replies: 3 Scorpian evo 3 mag pouches Views: 22,136 Posted By Ourindar I used to run Tasmanian Tiger large open-top... I used to run Tasmanian Tiger large open-top pistol mag pouches for my Scorpion. Have to re-insert at a bit of an angle, but they worked awesome. Very easy with a bit of practice. ...

Forum: Airsoft Guns Discussion February 5th, 2020, 09:18

Replies: 6 What do you think of the vfc samurai edge? Views: 21,759 Posted By Ourindar The Samurai Edge has a programmable system, just... The Samurai Edge has a programmable system, just like the Virgo. Also, are we on different Reddits or something? Like 50% of r/airsoft seems to think Krytac is the best gun that has ever been or...

Forum: Airsoft Guns Discussion February 4th, 2020, 19:12

Replies: 6 What do you think of the vfc samurai edge? Views: 21,759 Posted By Ourindar If the trigger board is the same as the one in... If the trigger board is the same as the one in the VFC/PTS VPSC Virgo, expect problems. Mine had an issue where it would work fine for like 30 minutes after plugging the battery in, then get upset...

Forum: Airsoft Guns Discussion December 17th, 2019, 17:01

Replies: 1 Sneak Peek: G&G G2 Cobalt Kinetics BAMF Views: 11,530 Posted By Ourindar Been curious about the parts compatibility of the... Been curious about the parts compatibility of the G2 gearbox, so I'm especially glad to see the internals part of this review for that reason alone. Thanks!

Forum: Doctor's Corner November 1st, 2019, 20:07

Replies: 2 TM USP (Full Size) O-Ring Replacement Views: 20,022 Posted By Ourindar TM USP (Full Size) O-Ring Replacement Hey folks, I bought a Tokyo Marui USP a while ago, and sadly the o-rings in the magazines seem to have gone (the mags leak gas visibly around the edges of the bottom). I grabbed a set of...

Forum: Airsoft Guns Discussion October 7th, 2019, 07:51

Replies: 6 Avatar Grenade Not Holding Gas Views: 223,212 Posted By Ourindar Yes, a few weeks ago and then again last week.... Yes, a few weeks ago and then again last week. They haven't gotten back to me so far. I've taken it apart and replaced o-rings to no avail.

Forum: Airsoft Guns Discussion October 6th, 2019, 18:07

Replies: 6 Avatar Grenade Not Holding Gas Views: 223,212 Posted By Ourindar Well that really sucks. Give us an update if you... Well that really sucks. Give us an update if you figure out anything, eh?

Forum: Airsoft Guns Discussion October 5th, 2019, 20:16

Replies: 6 Avatar Grenade Not Holding Gas Views: 223,212 Posted By Ourindar Avatar Grenade Not Holding Gas Hey folks, I bought an Avatar grenade a few months ago and had it go off exactly once before having issues. It doesn't hold gas at all. When you fill it, the gas just blows right out the spot...

Forum: Airsoft Guns Discussion June 10th, 2019, 20:19

Replies: 13 VFC Avalon Calibur Carbine vs krytac trident 2 Views: 20,726 Posted By Ourindar Honestly, I'm not even sure Krytacs are better... Honestly, I'm not even sure Krytacs are better than VFC out of the box anymore. We had a father + son duo show up recently with a Krytac SPR and one of the newer VFC Avalons. I can't speak to...

Forum: Gear Discussion April 17th, 2019, 09:59

Replies: 5 Can't decide on a start gun that will last. Help with selection? A beginner looking for a starter gun that will last. Views: 9,784 Posted By Ourindar Seconding the MAS Blackout. Solid gun. Seconding the MAS Blackout. Solid gun.

Forum: Airsoft Guns Discussion March 7th, 2019, 09:19

Replies: 1 VFC M27 IAR, EPM's? Views: 5,113 Posted By Ourindar VFC M27 IAR, EPM's? Hey folks, I was almost ready to pull the trigger (no pun intended) on one of the new M27's with the Avalon gearbox when I remembered something. I'm not terribly interested in getting a new set...

Forum: Gear Discussion March 5th, 2019, 11:03

Replies: 3 Prescription Inserts: A Dumb Question Views: 10,896 Posted By Ourindar You guys are fantastic. Thanks a lot. I'll just... You guys are fantastic. Thanks a lot. I'll just have to contact some local shops and cross my fingers. The goggles might fit over my glasses - I've heard people say these fit over theirs - but I'll...

Forum: Gear Discussion March 5th, 2019, 07:42

Replies: 3 Prescription Inserts: A Dumb Question Views: 10,896 Posted By Ourindar Prescription Inserts: A Dumb Question Hey folks, I've got a set of ESS Turbofans coming in. I bought them because I tried a set on and they fit great over my glasses (and I'm tired of replacing cheaper ones). However, I realized after...

Forum: Newbie Tank March 1st, 2019, 13:10

Replies: 2 Haven't played in 2 years, anyone able to fill me in on what's happened? Views: 5,419 Posted By Ourindar Can't speak much to your region, but I'd say... Can't speak much to your region, but I'd say nothing has really changed in terms of brands. From my experience: VFC and LCT still make the best AEG's, only real difference is pretty much all VFCs...

Forum: Airsoft Guns Discussion January 4th, 2019, 14:12

Replies: 13 Is airsoftmi.ca legit and quality guns? Views: 16,416 Posted By Ourindar Sssshhhh, don't scare away the new accounts that... Sssshhhh, don't scare away the new accounts that always post after a new account posts a new store.

Forum: Airsoft Guns Discussion October 7th, 2018, 16:12

Replies: 3 TM 5.1 Hi-cappa Views: 5,909 Posted By Ourindar What model were you looking for? Trigger has one... What model were you looking for? Trigger has one of the 4.3's and the 5.1 stainless in stock.

Forum: Upgrades & Modifications September 11th, 2018, 18:42

Replies: 0 Cybergun FAMAS F1 EVO Upgrades? Views: 6,775 Posted By Ourindar Cybergun FAMAS F1 EVO Upgrades? Hey folks, Just picked up a FAMAS on here (the newer Cybergun one with the MOSFET) as a backup gun. Didn't plan on really doing much else with it, basically just in case my main gun goes down or...

Forum: Gear Discussion September 2nd, 2018, 15:35

Replies: 4 Comms Setup: MSA Sordins Views: 10,254 Posted By Ourindar Thanks for your reply. Do you have a link to... Thanks for your reply. Do you have a link to the Comms Sordins? Can't seem to find them anywhere in Canada with a quick search. I checked SRS specifically as well, and they sell the conversion kit...

Forum: Gear Discussion September 2nd, 2018, 10:17

Replies: 4 Comms Setup: MSA Sordins Views: 10,254 Posted By Ourindar Comms Setup: MSA Sordins Hi folks, Total comms noob here. My only experience with radio communications is with the dinky little earpiece that comes with a Baofeng. What will I need, other than the headset and radio...

Forum: Newbie Tank August 2nd, 2018, 13:50

Replies: 8 im new to airsoft, and i have a few questions about my evo 3 s1 i just bought Views: 10,471 Posted By Ourindar I recently sold my Scorpion EVO, but it was an... I recently sold my Scorpion EVO, but it was an absolute blast, so I'll pass along my (subjective) experience with it. First of all, that thing is warrantied for a year, and if you use it as much...

Forum: Gear Discussion July 23rd, 2018, 16:53

Replies: 21 Where do you put your empty mags ? Views: 30,386 Posted By Ourindar +1 for just re-inserting your mags into their... +1 for just re-inserting your mags into their pouches. Maybe I'm about to commit heresy here, but if push comes to shove, I just keep the empty in my hand. I use Tasmanian Tiger retention pouches...

Forum: Upgrades & Modifications July 13th, 2018, 19:35

Replies: 1 Thinking about CZ 805 Bren, worried about upgrades. Views: 6,361 Posted By Ourindar Thinking about CZ 805 Bren, worried about upgrades. Hey everyone, I'm thinking about buying a CZ 805 Bren, but I'm a bit worried about upgrade potential. I want a gun that can compete with the best, and I'd like something that's not just another...

Forum: Tactics, Techniques and Procedures April 2nd, 2018, 15:30

Replies: 25 Is "No Duff" Still a Thing? Views: 70,955 Posted By Ourindar It's still in use in Nova Scotia. NSA has it in... It's still in use in Nova Scotia. NSA has it in their waivers/rules docs and ICBA (my 'home' org) has it in ours as well. It's something we generally explain to new people. Seems to me like a...

Forum: Gear Discussion April 1st, 2018, 10:42

Replies: 16 Looking for a chest rig.. Views: 23,237 Posted By Ourindar I'm looking into getting a Tasmanian Tiger... I'm looking into getting a Tasmanian Tiger Modular Chest Rig now, take a look at that, Katipunero.

Forum: Gear Discussion March 19th, 2018, 18:30

Replies: 16 Looking for a chest rig.. Views: 23,237 Posted By Ourindar Thanks for the responses guys! I was looking at... Thanks for the responses guys! I was looking at 5.11, what model is it you have? If it's the TacTec, can you get a MOLLE 'bib' for the front? Likewise for the Tactical Tailor stuff, I noticed the...

Forum: Gear Discussion March 19th, 2018, 11:04

Replies: 16 Looking for a chest rig.. Views: 23,237 Posted By Ourindar Looking for a chest rig.. Hi everyone, I'm in the process of trying to find a new chest rig, and I'm having a bit of a rough time. My old rig is a Condor Modular Rig (this guy:...

Forum: Reviews December 30th, 2017, 15:28

Replies: 5 Niagaraquartermaster.com Views: 17,226 Posted By Ourindar Friend of mine just received a new gun from them... Friend of mine just received a new gun from them today. He had them do a spring change on it, it was in the mail the next day.

Forum: Airsoft Guns Discussion October 12th, 2017, 14:01

Replies: 1 Mid-Caps for AY AS VAL? Views: 5,314 Posted By Ourindar Mid-Caps for AY AS VAL? Hi folks, I got an AY AS VAL in a trade a little while ago. Fun little gun, but it only had a hi-cap with it. Does anyone know where I can get mid-caps for it, or what other brands would be...

Forum: Doctor's Corner September 19th, 2017, 11:18

Replies: 8 Requesting Help With ICS L85A2 Views: 8,949 Posted By Ourindar The part of the wire that snapped was the... The part of the wire that snapped was the connector to the motor terminal on the positive end. I don't think that had anything to do with the noise. Just a weak connection to resolder. The noise was...

Forum: Doctor's Corner September 17th, 2017, 16:30

Replies: 8 Requesting Help With ICS L85A2 Views: 8,949 Posted By Ourindar Thanks a bunch. I pulled the trigger contact... Thanks a bunch. I pulled the trigger contact down and the gun worked... sorta. It made a really loud, strange noise and smelled like something was burning. When I went to pull the motor contacts to...

Forum: Doctor's Corner September 16th, 2017, 17:26

Replies: 8 Requesting Help With ICS L85A2 Views: 8,949 Posted By Ourindar Thanks for your reply. Here are some... Thanks for your reply. Here are some (hopefully) more helpful pictures of the unit. Like I said, I remember them both being flush with one another. https://imgur.com/a/70bl9

Forum: Doctor's Corner September 12th, 2017, 19:33

Replies: 8 Requesting Help With ICS L85A2 Views: 8,949 Posted By Ourindar Thanks for your reply. I've put electrical tape... Thanks for your reply. I've put electrical tape over the motor terminals and replaced the fuse for good measure. Measuring across the trigger contacts (with the lower off) with a multimeter, I get...

Forum: Doctor's Corner September 11th, 2017, 16:06

Replies: 8 Requesting Help With ICS L85A2 Views: 8,949 Posted By Ourindar Requesting Help With ICS L85A2 Hey folks, I recently got a used L85A2, it shot fine when I got it. Today, I decided to change the position of the pin that lets you adjust the FPS. It shot fine afterwards but I had a hard time...

Showing results 1 to 33 of 33