G36c Accuracy problem
 

Picked up a TM G36c and its either not aligned with the Iron Sights, or its shots are coming out too low.

Basically everything looks like its deviating about 5-10 Degrees down from the mark made by the iron sights.

Tryed equipping a Red Dot scope on it and it won't adjust low enough to match up with the shots.

So im guessing its something to do with the hop up. but i have no idea how to properly adjust this and get a better result. also i think i may have screwed up the way the mags feed into the hopup while i was "tinkering".

Any ideas on how to get it to shoot more leveled and match up with the iron sights?

I might need to take it to a gundoc...

how far are you shooting at the target? Honestly it sounds like you are shooting too close.

Have you adjusted the hop up?

Have you cleaned the barrel? May be dirty inside... that can affect shot drastically

You don't know how to adjust the hopup you say? Or you're adjusting it and it isn't doing anything?

When you picked it up, was it new? Is it stock?

appears to be stock, but its not new. i suppose i am shooting too close. how far away should i be to set and adjust my red dot?

and secondly, i really don't know how to adjust my hop up/what i am adjusting when i adjust my hop up.

Also, where do you recommend i pick up a cleaning kit if im in the GTA?

thanks alot for the answers guys

shoot from at least 50-75 feet MINIMUM or your sights will be pretty useless in games. for the hopup, pull back the charging handle (underneath the top rail) to open the ejection port on the right side of the gun, there will be a sort of wheel, spin it downwards for more hop, up for less (MAY have the directions backwards for adjusting the ruber though)

Thanks alot dude, sorry for the newbish comments. now the only question is, where am i going to find 50 feet to use as a "range". lol

field