SPR Project Done
 

Well 99.5%, still waiting on my trigger guard and m150 spring. Another problem I ran into was the end piece of the SPR flashider was not wide enough to accommodate the barrel so I'm trying to figure out what to do with that. Anyway, comments welcome!

Complete Systema Gearbox
Systema Magnum motor
Systema tightbore
G&P hop-up with systema bucking
G&P bushmaster body
CA SPR front
CA SPR pistol grip
CA full stock
Guarder Steel trigger
Guarder Selector switch
Systema bolt catch
CA rear flip sight
RS Armalite SPR rail
G&P mag release

http://www.simviation.com/yabbuploads/100_1941spr.jpg
http://www.simviation.com/yabbuploads/100_1939spr.jpg

Is the real one suposed to have the full auto mode?

Probably not, this one will be made semi only either way, cant do much about the auto marking though.

Edit: Found this, only a render though so it could be wrong

http://www.dogfightink.com/SPR.jpg

Sure ya can, find some putty and fill it in. If you want to get something really tough look for Bond-O at your local Crappy Tire :P.

Looks good, you can always use a suppressor to cover the overly long inner barrel, which is what I did to my SPR.

That rail almost looks the part but not quite for purists like me hehe. It's those funky knobs and Knights BUIS on top of the rail makes it look odd to me. Aside from that it's still a excellent try at the SPR and I hope it shoots as good as it looks.

What suppressor would you recommend? As far as the rail and sight, until I get money, it makes the gun unique hehe

SPR/a = yes full auto, SR-25 = no full auto, them there is the SPR which I've seen both of.

OPS Inc

http://img.redwolfairsoft.com/upload...GP-GP775_L.jpg

Thats nice lookin, the problem is that I cant fit the end piece of the flash hider.

Edit: Never mind, I guess it just includes the flash hider

Don't paint it now like you did to your VFC! :P

If you want to go with the "issued" look you would use the ops inc can like ex-royal suggested. I would suggest dremmeling out the inside of your flash hider to fit over the barrel , ive had to do it plenty of times.

What size bit did you use?

Just one of the smaller grinding wheels.