Hi-Capa valve installation
 

http://www.wgcshop.com/WGC_Shop/images/gd_v_capa08a.jpg

I assume this replaces the spring and piece of plastic that goes inside the loading muzzle. The question is, how do I put it in? The button-like piece on the top of the valve seems to be too big to fit inside the plastic 'ring' that screws into the loading muzzle.

Loading muzzle
http://www.wgcshop.com/WGC_Shop/images/gd_pt_capa13.jpg


Thanks.
-VM

That's the gas release valve, it goes in the mag... not in the nozzle.

Well now, that explains a lot.

Lol.

How do you open the magazine? I don't see any screws.
-VM

The old valve unscrews and the new one goes in it's place. Just make sure there's no gas in the mag before taking out the valve. I got a special key from Jugglez to remove mine but it could be done with a pair of needle-nosed pliers. Be careful if the ring with the two notches on it is brass.

You'll need a valve tool.