Changing PINION gears..WTF!!!???
 

I know there is a tool for removing pinion gears but who has one?
I have 3 good motors with strippped pinions and just want to change the gears.

Any suggestions?

well if its like changing gears on a bigger electric motor your ganna have to heat the gear up and use a bearing puller to get it off as its probably shrunk fit

WGC has tool but it SOLD out.

http://www.wgcshop.com/pcart/shopper...GRV2_cat_Tools

It is possible to remove a pinion gear with a steel vise. Grip the bad pinion firmly and punch the motor shaft out with a 3/32 punch.

The new pinion can be pressed on by clamping the the motor and new pinion lengthwise to push it onto the shaft. It is VERY important that you do not load the motor bushings in this direction so put a 1/8" ball into the end bell (other end where the brushes are) so when you press the whole thing, only the pinion and armature shaft are loaded. Also put a firm pad (plastic or even stacked paper) on the face of the pinion so you don't mar it with a textured steel vise jaw.

Well I finally had a pinion gear give up the ghost... Madmax's technique worked slick. Used a large C-clamp to squeeze the new pinion onto the shaft.

Mods should throw this in AEG solutions.