Motor vs batteries
 

Hi everyone, I want to know if 9.6 2200 mha batteries are suitable for a G&G hi-torque motor?

Yes. Your rate of fire will be great.

Anything else? Any upgrades?

if its a stock G&G gun i wouldnt recommend anything over 8.4
G&G internals are REALLY bad
if its upgraded, 9.6 is fine

Ok so should I replace something in my gearbox for it to be safe whit 9.6 2200 mha batteries?

Metal bushings would be a good idea.

Thank you, I have looked on some airsoft retailers for Metal bushings. I've only found full tune-up kit, do you know if I can buy it separately and if yes where.

I have metal bushings for sale.

http://www.airsoftcanada.com/showthread.php?t=495

Also, if you install a stronger spring, it will balance out the load requirements of your battery and motor.

Well thank you! and about the spring, guarder 110 would be ok ?

Ho! and I also want to know, whats causing high-pitched noises on a AEG because I'd like to fix this, even if it's juste for the (good looking)

once again thank's for your support!!!!

Could be motor adjustment, small allen screw at the base of the grip, turn it till it gets quieter. But sometimes even at the perfect spot theres some whine, just cant silence it all, without a Silent kit that is.

The whine could also be from poorly shimmed gears, but if you bought your gun brand new and stock, it's most likely not that.

If you did the motor swap and got the whine, then it's most likely your motor height that needs adjustment.

If you want more choices for where to buy parts, get your age verified by one of the local representatives. Then you will have access to the Classifieds Section.

Before you mess around with your gun, I highly recommend that you have someone with experience look at it first. There are plenty or experienced folks around Montreal, and they can verify your age at the same time.

Finally I have changed my gearbox for a G&P v2 with bearings.
And now, I'd like to change my motor. which one in more suitable for my 9.6 2200mah batteries, Marui eg700 or marui eg1000?

Both will do the job fine, it just depends on what you want to achieve.

whats it's going to change from one to the other?