glock problem mag. please help
 

i have a glock with metal slide with metal mag

when i fill the mag up i can only shoot oncw and no more gas

i use green gas.

i fill it for about 2-3 seconds 3 times.

i can only shoot once and then it wont work

o ya i submerged it in watter. the mag. and i see no bubbles

Read the information section. It says how to care for a GBB and also how to fill it with gas.
I bet you are not filling it the right way.

You have the take the magazine and turn it Upside down, turn the gas can so the tube faces down too, and fill the magazine with the Liquid gas. You should get at least 2 full mags of shooting with one fill.

If you want better information, say exactly what kind/brand of Glock you have. Maybe one of the models is a problem.

Here's the freebie of the week; http://www.airsoftcanada.com/showthread.php?t=21513

i had no problems with my glock. i filled it up and fired it many times. and i know how to fill up a mag.

now when i fill it up today for some reason i fill it for 2 sec 3 or 4 jabs. and still very little gas or no gas sometimes.


and ya i flip the maguside down when i fill it up

Bring it to a gun doctor then.

Does it spray out all the gas on the first shot, or does it only have enough power for one shot? and does that one shot cycle all the way?

i srpays all the gas out all at once i think.

i like the buttone that releases the gas on the top part of the mag. i pushed it and it had like a 1 sec sound and then no more gas.

and i did put alot of gas.

Have you tried using a new can of gas? There may not be enough gas left in the can to fill your mag.

Oil is the answer, I've dealt with numerous occasions of people saying the gas spews out in one lump amount, every time I tell them where to oil, it fixes it.

Remove the slide. Put your thumb over the hammer, pull the trigger and let the hammer drop carefully. You'll see the little part (#78 I think, not sure) that hits the mag's release valve. Dump a good amount of silicon oil on the axle of this part, and oil in other areas around moving parts in the gun. Repeat the thumb over hammer, pull trigger thing numerous times to work the oil in, then put the slide back on and shoot it.

Also, hold your empty of gas mag face down, put a good drop of oil on the release valve button (rear), then press and release the valve numerous times. Could be your valve is sticking as well.

Let us know what happens.

solved thx

So you had never oiled and maintained that gun??? Check the basic information on how to care for GBB guns, and follow that.

Safe to assume my suggestion is the one that worked? GBBs require relatively frequent oiling (and grease on the metal on metal contact points, such as where the slide moves on the frame) to keep them running smooth and reliably. And make sure you always keep a small charge (at a minimum) of gas in the mags to prevent any future problems with leaking.