VSR 10 air leak
 

Gents, I'm seeking advice from the vsr10 masters out there.

I have a TM VSR10 that is PDI upgraded but I have a consistent air leak from the rear of my hop up rubber. Every rubber I tried still yields a leak. I'm also using the stock hop up chamber. The only solution I can think of at the moment is to add heat shrink on the nozzle to create a tighter fit.

What do you guys think.

Thank you

What kind of air nozzle do you have?
My PDI nozzle had an O-ring on it that pretty well guaranteed I wouldn't have an air leak there

I have the newer version. I used to have the version with the o ring. But the o ring kept on breaking or destroying the hop up rubbers I found due to over stretching.

Are you using the new version nozzle with the old version pdi hop up?
If so thats yer issue right there
The new "version 2" hop up is a lil different in size hence the new nozzle a stock nozzle should work fine with the new hop up but doesnt with the old stule