Cyma SVD Feed?
 

Just took it out to plink with new bi-pod and scope. Started to fire and it is firing 2-3 bb's at a time. Took mag out tried different mag same issue. Will fire one shot right on each mag change then every other shot is 2-3 bb's at once. Everything on the gun is stock. What could be the issue?

hop up problem check the rubber!

Argh KK, was going to take it apart and put on a new tight bore and the r-hop kit. So I guess it's kind of a win win. Thanks alot off_killer!

Would you know what kind of hop-up the svd takes? Is it just a standard ak one?

its a clone of the Real sword so a real sword SVD hop up should work

Do you know of a retailer in canada?

Another thing, do you think it's just needs adjusting. Or taken apart to be cleaned and make sure everything is fitting it nicely?

Looked at the hop up last nice when changing the barrel out. Looks to be no problem but I've never used this time of hop up before/ THe top switch I guess is to adjust everything?

If you take out the little screws you can take the top off which will allow you to see where the nub goes. Make sure it still has one.

Thank you. Just checked looked like it was abit out of place, fixed it and is now working properly!

Looked at it again today. Still double feeding with the mag in. It fires two bb's with one trigger pull. the hop up is in good working conditions and everything else seems to be working fine. the nozzle moves freely still when you push a finger on it.

When i turn the gun upside down and fire it just putting a couple bb's into the hop-up in feeds perfectly. Just when the mags are in it. Can this be mag issues feeding too much bb's into it?

With the hi-cap that came with it. t's still doing the same thing unless I hold the gun upside down :/

Or

could it be that the bucking isn't pushed back enough on the new barrel?

Does the pronlem dissapear after a few shots?

Nope. I can go through a 90round mag and it only takes like 20 pulls. Just stays there no matter what.

I think you need a gundoc

No money for a gun doc atm :'( I just think it's the bucking not sitting far enough back. I'll double check when I get home. Really hoping to get this fixed without needing one. ><