Shimming SR16 Motor Problem
 

Is there something im missing. Ive got one of the little round metal shim things but i cant get the motor to sit just right that and the wires in the pistol grip are limiting movement for the motor. Any suggestions?

I had the same problem... I placed the wires on the same side in the pistol grip... and all is working ok now...

Hope it help's

nono there in the pistol grip but now its to tight for the motor and i cant get it shimmed right.

sr16 wiring
 

yes it is a pain in the axx to fit the motor into the M4/M16 grip. Based on our experience, all wires must go from the rear side of the grip to the motor.

The wires need to run inside the grooves on the rear interior of the pistol grip.

they are right body, it is common to retry 3 to 4 time to replace the wire.
push them with your finger or a tool to be sure they are contourning the motor hole and that the spring of the motor wont touch them. Then let them run on the rear of the pistol grip. It should have a groove there. Then before placing the spacer and the butt cap be sure by pressing the motor down the hole that it fully release when you remove your finger. If not, replace the wire, it wont work. Now when you put the cap, look for the wire to not get in the butt cap groove path.
I could not be more clear, or can i?

well said
its a common and overlooked problem
as I said in another thread on here, a new grip to replace the shitty TM one can help.