ZSH-1(-2M) dimensions needed; please help!
 

I plan to build ZSH-1-2M(no face shield!!!) similar method used at my custom mask(I'm cheatin' a bit; I used silicon form, not that plaster one):
http://i786.photobucket.com/albums/y...h_P9250079.jpghttp://i786.photobucket.com/albums/y...h_P9260081.jpghttp://i786.photobucket.com/albums/y...h_DSCF0299.jpghttp://i786.photobucket.com/albums/y...h_P5240004.jpghttp://i786.photobucket.com/albums/y...P5290015-1.jpghttp://i786.photobucket.com/albums/y...h_P6030013.jpg

http://i786.photobucket.com/albums/y...e5-d4hks72.jpg
So I would need some dimensions from a RS ZSH-1-2M:
http://i786.photobucket.com/albums/y...h_measure1.jpghttp://i786.photobucket.com/albums/y...h_measure2.jpghttp://i786.photobucket.com/albums/y...A1253_I3-1.jpg
I need(mms-or cms):
-maximum windth
-maximum length
-height
-material thickness at the edge
-rubber windth covering the edge

As I know ZSH-1-2M is smaller than ZSH-1, so hence the lower photos are from ZSH-1(as I know), ZSH-1-2M would be better...

Thanx 'comrades': Flippy

Got dimensions from redalliance, and made:
First positive form from polystyrene, and paper:
http://i786.photobucket.com/albums/y...elmets/ZSH.jpg
After that negative mold from special silicon, and plaster (plus some foam outside to protect the mold):
http://i786.photobucket.com/albums/y...s/P7030280.jpg
And the helmet (layers of polyesther laminate outside/inside, and small PUR foam blocks between the layers):
http://i786.photobucket.com/albums/y...s/DSCF1377.jpg
http://i786.photobucket.com/albums/y...s/DSCF1414.jpg
Inside is from my Mich 2000 helm...
http://i786.photobucket.com/albums/y...ps427c6ff1.jpg

Incredible build!!! I wish I had your skill set... I totally would've made my Maska 1sh a long time ago haha.