Sig 552 Front Receiver(Handguard) Pin
 

Hello, fellow members of ASC.

I have lost the front handguard pin on my JG Sig 552 and have been looking for a replacement with no luck.

I tried looking for a TM Sig 552 handguard pin, but everywhere I checked didn't have it or it was sold out.

All I have found were some ICS handguad pins from Evike.com.

I was just wondering will this work with a JG Sig 552, and if not, are there any alternatives to replacing it(such as using the pin from another gun)?

Also, G&G makes a Sig 552, will the body pin on those work with a JG?

If anyone has any links, can you please post them.

I don't know the answer to your question, but I don't recommend an ICS pin. It's completely different from the GG one. As far as I know, each company has a little something different about their SIGs. I believe the JG is a clone of the Marui, though.

Inb4sigsignal

Link to the pin? It would be easy to compare TM/JG to ICS.
A G&G one will not work (at least not as intended, they're the same as real steel ones).

http://www.dentrinityshop.com/photo/OTA_S/tnsig002.jpg

Comparing this image to my ICS pin, it appears that the position of the two nubs that prevent it from moving are in a different place between the Marui and the ICS. The ICS nubs are right at the bottom, whereas Marui's pins look like they're only 3/4 of the way down the pin.

Tarobear has linked what the pin looks like, and yes I know that a TM one will work. It's just that it has been difficult to find one(everywhere I checked was sold out), and just wanted to see if there were any that would fit.

If that reference photo is correct, I don't see how the ICS pin would work in the JG.

zipties have been holding the front ends of my mp5s for years now.

You can find it on Ehobby
http://shop.ehobbyasia.com/well-rece...ig552-aeg.html
it fits my JG sig 552