MP5 Hopup unit
 

Hey all,

I am planning on upgrading my Aftermath Broxa, and I've been reading on here to replace the hopup unit, bucking and barrel.

My problem is, I can not for the life of me find a new hopup unit (since the stock one is not compatible with after market parts?). Everyone says to get a TM one, but I can't find one. I've come across a CA one, would that be okay to go with.

Also, would it be better to pick up a Black Python 6.03mm TB, or a Madbul 6.01mm TB?

Thanks if anyone can help with these slight road bumps.

TM and ICS would work they're both the same... I thought broxa didn't come with a hop up

Would you be able to point me in the direction of either of those hopup units? Preferably on a Canadian site, but doesn't really matter,

I love how airsoftparts.ca is now the answer to everything, when they don't have a TM or ICS hopup (which is what was being discussed).

By aiming me there though, I am going to assume that since the CA hopup is the only MP5 one they carry, that it is adequate?

I think the TM hopup are shit to begin with... Plus there hard to find...
The CA fits...

If your hopup is fine, just get a tight barrel

What kind of mods are you doing..? Higher fps or just stronger internals..?

Well, from what I've read online the Broxa hopup unit wont take new barrels.

I just wanted to squeeze a bit more accuracy out of the gun, since shots go pretty much everywhere at 100ft. So, Tight bore, new hopup unit, and I was looking at getting the ARS AEG hop-up rubber.

I haven't tested the compression on the cylinder, piston, etc yet. But depending on how that is, and how it goes after taping, I may replace those.

I see, good luck