bullet ant goggle problem
 

I just picked up a pair of Revision Bullet Ant goggles, and I'm having trouble getting the clear and yellow lenses to fit. The goggles came with the smoke lenses installed, and they fit fine, but it seems that the clear and yellow lens sets are a bit bigger than the smoke ones, and because of this they don't fit in the goggles properly.

Has anyone else had this problem? I'm wondering if I should just take them back and ask what's up... I can physically get the lenses into the goggle, but the tabs don't lock in properly...

Any ideas?

I have never dealt with them before. what you could do is take the tinted goggles and look at where other 2 are larger and sand them down little by little until they just fit.
be careful though because you could make them too small and they will pop out too easily.

Yeah, thought about that but they're like 3mm bigger on each side, dont wanna risk messing them up..

Assuming you bought them at PSA due to location go in and talk to Shayne. He could show ya.

Just email Revision Eyewear. Their Customer Service is beyond amazing and they'll help you out real quick.

customercare@revisionmilitary.com