Motor Tabs
 

Does anyone have a good solution for a broken motor tab/ connector? It seems they were bent too much and snapped off.
Thanks

Find someones broken motor and replace the ends... Otherwise, soldering wires direct or making your own tab and attaching it to the screw of the motor end.

if you go with this method, i would suggest you make sure the wires are long enough to reach the tabs. sounds stupid and obvious but, youd be surprised..

there are systema replacements from ehobby.

get a thin piece of metal and shape it to be a tab. Then bore a hole in it the size of the screw in the end of the motor. Remove the screw and place the new tab and screw the new tab in place. Works great and is cheapest method.

good stuff. thanks for the suggestions.