CA M15A4 Gearbox Problem?? PIX Included
 

Are there little gaps where the cylinder is seen through the gearbox normal? I have never seen this, and I'm pretty sure it is a problem. I want to buy all new insides for it but they probably won't do much good if there's a big hole that isn't supposed to be there. It almost looks as if a little chip has been taken out of the metal. Sorry for the bad quality pictures.

Thanks

Is it rounded? Some manufacturers round out the corners so they're less prone to failure/breakage, as the front of a V2 is prone to failure.

Be thankful for those mods...finally someone is doing it. Or is this a used AEG and the previous owner did it?

Either case...its a good thing.

It's used but I don't think the previous owner did much to it. Awesome that it's a good thing though. This thing should last a long time then (hopefully).

I have a jg box that is like that. Compression is fine. I thought it was just the way they cut it. Sorry to thread jack but what is the point of this?

relieves stress on the mechbox with a rounded corner

^thanks;) Prompt answer lol