Looking for someone to build a custom programming cable.
 

Can you read and build a radio programming cable from schematics? If you understand the following schematic and can build this cable for me, please contact me via PM. If the cable is successful, there would be a large number of people who would be willing to purchase one. *Disregard the Note about the bps rate
http://lh6.ggpht.com/_ldqZux8lyBs/TF...%20Diagram.jpg

Seems to me you need the cable with the proper connector to start with. No connector type or pin outs are listed, nor are component types, although a diode is a diode, SPDT switch is easy enough, and the pull up resistor values are at least given (but not the other three resistors). One would assume this would be built inside a small project box also.

I'm not volunteering, hence my not contacting you via PM. :P

Looks as though I found someone that will do it.

Cool.