Magpul MOE handguard for TM compatible M4
 

I know that this handguard is not compatible with TM guns. What type of modification would I have to do to make it fit? Would it even be worth it? Are there any other similar handguards available for TM models?

http://www.airsoftpost.com/product_i...ducts_id=30868

This link has more information about the handguard. I'm going to buy it off of eBay

I have been thinking that you may be able to shave the rear ends of the 2 pieces a bit to make them fit into a TM Delta Ring. When I tried one, the length seemed too long and the TM Delta ring could not accommodate the back end. The alternative is to get a CA front end/ Delta Ring and attach that to your TM body, minor modifications may be needed there as well.

Maybe someone here has fitted these to a TM frontend but I couldn't do it without modifications. I have some in stock if we ever meet at an operation you can try them and see what you think, if you could make them fit.

OK, before I posted I went to see if I had what I needed to check this out. Looks like you could modify one to fit. It actually looks to be about 2-3 mm too long and the Delta Ring has those 2 lugs where the CA type is more like real steel and has a "bicycle gear" type appearance. The back end of the Magpul grips has a groove to accommodate the "bicycle gears" but not the lugs of the TM.

Update Mr. Heatscore. I tried the grip on a TM delta ring and it fits snugly into it. Disregard what I wrote above. However I do mean snugly. The delta ring is not on a barrel and has no spring in it. It does fit however! It is just a matter of getting the length on the barrel correct. The front sight has to go ahead that 2-3 mm.

PM sent on AAS.