Huang's (Dragon Red Airsoft Outlet) T-1 Micro LT660 Problem
 

i just got myself a T-1 micro with LT660 Replica mount. The low-level pictinny rail was fine but I need the high riser, when I install it it was not a perfect match, the sight was on an angle. I was like err what ever, I'll just compensate with windage and elevation adjustment. Bigger problemw as the quick release mount, I cannot close it completely, the metal will dig into my upper receiver. (PTW and Prime)
I'm just wondering if anyone has these problems. If you do, what did you do the fix it? Worse comes to worse, I'll just get the LT660 mount, will that work with the replica?

RS mounts will work on the replica.

I have the same problem with most QD China stuff. Poor rails.

Mine fits all my VFC, TM, and KWA rails with both the low and the Laure mount copy.

Maybe take a close look inside the mount where it meets the rail to see if there's a little burble of material that's causing your problems.

From what I can tell its bad molding of cast metal, I could try slowly sanding it away but I fear it will ruin the integrity of the mount.
How much and which brand of the riser did you bought Hitman?

Don't have one, but I know they do fit on RS. LT660 goes around USD $100, try ebay. lol

I got mine today too and I have the same problem with the LaRue replica riser. You can disassemble the throw lever and release some of the tension on the spring inside it. Be careful. The spring and washer almost hit me in the eye. It's under a lot of tension.

did already, spend about 5 min of dremal, bad cast, bad painting. Honestly My spray paint job attracts less problems. and btw it wobbles a bit, I had to tighten the hex screw to ungodly strength to make it stop wobbling.
As for the riser fitting to optic, its 1mm OFF 1mm!!! so yea you can see through, Optic zero fine like it should be.

sounds good to me

file down the inner edge on the riser and it will work.