Originally Posted by .Zo (Post 1763159)

Also how the frick do I take out the bbu

I cant wedge it out

Originally Posted by p.phresh (Post 1763234)

remove the screw then the two pieces held in by the screw.
Turn the selector switch all the way up until it's facing the top of the slide and push it out gently.

*put your hand over top while you're popping out the selector switch, there's a tiny spring and detent pin you don't want to lose.

After that the BBU should fall right out.

Originally Posted by p.phresh (Post 1763384)

You shouldn't have to file a PGC barrel to get a TM hop chamber to fit. You have to kinda massage it in there. Push it to the side and tap it in. Don't file anything you might ruin the way the inner and outer barrels interact.

here's a youtube video of lazouche removing and installing a metal 1911 outer barrel, the barrel assemblies are different but the ideas are the same:
LaZouche Custom airsoft how to fit metal outer barrels. - YouTube

Originally Posted by .Zo (Post 1763550)

Oh and I just lost the slide stop spring.

Yay.

>.<

anyone know where I can get one?

Originally Posted by p.phresh (Post 1763558)

right in your own backyard:
http://www.evike.com/product_info.php?products_id=41151

or should you decide to lose more springs:
http://www.evike.com/product_info.php?products_id=30681

Originally Posted by .Zo (Post 1763308)

This PGC outer barrel is really being a pain in the ass.

The hop up unit wont fit in it so now I have to file all this shit

Originally Posted by e-luder (Post 1763573)

It fits. It's just hard to get the hop up unit inside the chamber. The PGC outer Barrel is actually one of the best accommodating outer barrel out there for Glocks.



What is the "line marked" you are referring to?

Here's a video of the slide assembly take down on the G17. Fast Forward to the end. You kinda have to force the hop up unit in there but gently. If you just keep banging at it, you'll damage the inner barrel, the bucking and hop up unit itselt. But once it's in, the hop up unit should be able to move about whilst inside the chamber of the outer barrel.

Metal Slide and Barrel for Marui Glock 17 - YouTube

There is a notch on the hop up unit near the hop up chamber (where the BB enters) that will prevent you from inserting the unit into the outer barrel.. You need to lift that above the edge and then slide the hop up into place.