Quote:
Originally Posted by MikeMcNair
im sorry if i was unclear:
in the pic with the outer barrel in the drill; look closely, if you pulled the trigger the whole unit would spin, so you can polish the OUTSIDE of the barrel.
the inside of the barrel is held by the dremmel sanding drum (think of it as a plug per se.)
this was simply an example of using things around the house to get a job done quickly. (a makeshift lathe sotra :P )
if that still does not make sense, i will make a video.
I do have a Q for E-Luder:
Have you found a way to make the inner barrel NOT rattle against the outer barrel on these? In KSC/KWA world you can use O-Rings and it's a nice feature. i have yet to rid my current G26 of this last rattle, and it drives me nuts.
thank you in advance for your thoughts.
-Michael
|
The easiest way to eliminate the barrel roll is just simply wrap your inner barrel in some electrical tape. That's been the staple for years. lol.
It's hard for me to find o-rings that fit properly.
...and electrical is much more "modifiable" than an o-ring. That is, you can add or take away as much as you need. Whereas an o-ring doesn't share the same modularity.
...and and....It's cheap!!! (In every sense of the word.)
That's what I normally do.