Quote:
Originally Posted by e-luder
You can use any VSR-10 Marui spec inner barrel for an extended length.
Most of the Marui spec pistols use this inner barrel andHop up rubber system. So, you can use an extended Hi-capa inner barrel if you want.
And yes, it will stick out.
You'll need a threaded outer barrel for mock suppressor to cover/hide the long inner barrel.
The NineBall Gas Route packing improves the gas transfer from mag to loading muzzle and helps improve the gas consumption of your gun. Essentially, it's like shimming the rubber piece on your magaine to bring it closer to the loading muzzle air intake hole.
The only parts that are not compatible on a Glock 18c from a Glock 17 are:
-rear sight
-rear sight screw
-blowback unit
-loading muzzle
-trigger bar
-hammer
-hammer bearing
-full auto sear (extra part on the G18c. The G17 does not have this as it is only a semi auto Glock and thus does not require it)
-full auto sear pin and actuator spring
-Piston head
-slide
-fire selector
-fire selector plate and actuator spring
-hammer housing
I may have forgotten a few parts here and there but these are the important ones.
For the question of which bucking you should get:
For what you're after, I suggest getting either the NineBall purple bucking or the A+ Reaps buckings. These buckings have been known to give a little bit of a power boost and from my tests, they give decent range outputs.
|
Wow thanks, I think I am good to go!
Just one more thing, I accidentally ordered this.
DYNA Piston Head
Not sure if it's worth it, I actually don't know what i does.
Other then that, I am ready to get my glock going. Ive been playing with it as my primary lately I just can't get enough of it.