[e-luder]

Hi Turok,

I had my bearing custom made for that specific set. It was steel material and was measured to about 8.5mm. It almost the same size as the stock bearing.

I think the AIP bearing was measured to about 9mm( or very close to) and rubs the BBH the wrong way. The easiest way to get the slide to glide properly would be to pack either the hammer hook on the sear or pack the sear hook on the hammer by a hairline to push the hammer down even further. There is still a few millimeters of play before the mod. I was able to achieve the frictionless cycle by doing this but the material i used wore very quickly. And it took alot of fitting and reffiting for the sear and hammer which meant a lot of take downs and filing.

If i can find my hammer bearings i will send one your way. I dont know if i have them still though...I was giving them out earlier this year for free. lol.